Smc-networks ElliteConnect 2.4GHz/5GHz Manual de usuario descargar pdf (Pagina 67)

Initial Setup through the CLI

5-3

At the Exec prompt, type “country ?” to display the list of country

codes. Check the code for your country, then enter the country

command again followed by your country code (e.g., IE for

Ireland).

Setting the IP Address – By default, the wireless bridge is

configured to obtain IP address settings from a DHCP server. You

may also use the CLI to assign an IP address that is compatible

with your network.

Type “configure” to enter configuration mode, then type “interface

ethernet” to access the Ethernet interface-configuration mode.

First type “no ip dhcp” to disable DHCP client mode. Then type “ip

address ip-address netmask gateway,” where “ip-address” is the

wireless bridge’s IP address, “netmask” is the network mask for

the network, and “gateway” is the default gateway router. Check

with your system administrator to obtain an IP address that is

compatible with your network.

Dual Outdoor#country ie

Dual Outdoor#

Dual Outdoor#configure

Dual Outdoor(config)#interface ethernet

Dual Outdoor(config-if)#

Dual Outdoor(if-ethernet)#no ip dhcp

Dual Outdoor(if-ethernet)#ip address 192.168.2.2 255.255.255.0

192.168.2.254

Dual Outdoor(if-ethernet)#

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 321 322

Sin comentarios

Smc-networks ElliteConnect 2.4GHz/5GHz Manual de usuario Pagina 67