Smc-networks ElliteConnect 2.4GHz/5GHz Manual de usuario descargar pdf (Pagina 173)

Entering Commands

7-3

Entering Commands

This section describes how to enter CLI commands.

Keywords and Arguments

A CLI command is a series of keywords and arguments.

Keywords identify a command, and arguments specify

configuration parameters. For example, in the command “show

interface ethernet,” show and interface are keywords, and

ethernet is an argument that specifies the interface type.

You can enter commands as follows:

• To enter a simple command, enter the command keyword.

• To enter commands that require parameters, enter the

required parameters after the command keyword. For

example, to set a password for the administrator, enter:

AP(config)#username smith

Minimum Abbreviation

The CLI will accept a minimum number of characters that

uniquely identify a command. For example, the command

“configure” can be entered as con. If an entry is ambiguous, the

system will prompt for further input.

Command Completion

If you terminate input with a Tab key, the CLI will print the

remaining characters of a partial keyword up to the point of

ambiguity. In the “configure” example, typing con followed by a

tab will result in printing the command up to “configure.”

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 321 322

Sin comentarios

Smc-networks ElliteConnect 2.4GHz/5GHz Manual de usuario Pagina 173