Smc-networks ElliteConnect 2.4GHz/5GHz Manual de usuario Pagina 298

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 322
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 297
Troubleshooting
A-2
3. If the wireless bridge cannot be configured using Telnet, a
web browser, or SNMP software:
Be sure to have configured the wireless bridge with a valid
IP address, subnet mask and default gateway.
Check that you have a valid network connection to the
wireless bridge and that the Ethernet port or the wireless
interface has not been disabled.
If you are connecting to the wireless bridge through the
wired Ethernet interface, check the network cabling
between the management station and the wireless bridge.
If you cannot connect using Telnet, you may have
exceeded the maximum number of concurrent Telnet
sessions permitted (i.e, four sessions). Try connecting
again at a later time.
4. If all other recovery measures fail, and the wireless bridge is
still not functioning properly, take any of these steps:
Reset the wireless bridge’s hardware using the CLI, web
interface, or through a power reset.
Reset the wireless bridge to its default configuration.
5. If you forgot or lost the password:
Contact Technical Support.
Vista de pagina 297
1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 321 322

Comentarios a estos manuales

Sin comentarios