Smc-networks SMC2552W-G2-17 Manual de usuario descargar pdf (Pagina 248)

Rogue AP Detection Commands

7-111

Example

rogue-ap authenticate

This command forces the unit to authenticate all access points on the network. Use

the no form to disable this function.

Syntax

[no] rogue-ap authenticate

Default Setting

Disabled

Command Mode

Interface Configuration (Wireless)

Command Usage

Enabling authentication in conjunction with a database of approved access

points stored on a RADIUS server allows the access point to discover rogue

APs. With authentication enabled and a configure RADIUS server, the access

point checks the MAC address/Basic Service Set Identifier (BSSID) of each

access point that it finds against a RADIUS server to determine whether the

access point is allowed. With authentication disabled, the access point can

identify its neighboring access points only; it cannot identify whether the

access points are allowed or are rogues. If you enable authentication, you

should also configure a RADIUS server for this access point (see “RADIUS”

on page 6-7).

Example

rogue-ap duration

This command sets the scan duration for detecting access points.

Syntax

rogue-ap duration <milliseconds>

milliseconds - The duration of the scan. (Range: 100-1000 milliseconds)

Enterprise AP(if-wireless g)#rogue-ap enable

configure either syslog or trap or both to receive the rogue APs

detected.

Enterprise AP(if-wireless g)#

Enterprise AP(if-wireless g)#rogue-ap authenticate

Enterprise AP(if-wireless g)#

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 295 296

Sin comentarios

Smc-networks SMC2552W-G2-17 Manual de usuario Pagina 248