Smc-networks SMC2552W-G2-17 Manual de usuario Pagina 224
- Pagina / 296
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Spanning Tree Commands
7-87
7
Default Setting
128
Command Mode
Interface Configuration
Command Usage
• This command defines the priority for the use of a port in the Spanning Tree
Protocol. If the path cost for all ports on a wireless bridge are the same, the
port with the highest priority (that is, lowest value) will be configured as an
active link in the spanning tree.
• Where more than one port is assigned the highest priority, the port with lowest
numeric identifier will be enabled.
Example
Related Commands
bridge-link path-cost (7-87)
show bridge stp
This command displays aging time and spanning tree settings for the Ethernet and
wireless interfaces.
Syntax
show bridge stp
Command Mode
Exec
Example
Enterprise AP(if-wireless a)#bridge-link port-priority 1 64
Enterprise AP(if-wireless a)#
Enterprise AP#show bridge stp
Bridge MAC : 00:12:CF:05:B7:84
Status : Disabled
priority : 0
designated-root : priority = 0, MAC = 00:00:00:00:00:00
root-path-cost : 0
root-Port-no : 0
Hold Time : 1 Seconds
Hello Time : 2 Seconds
Maximum Age : 20 Seconds
Forward Delay : 15 Seconds
bridge Hello Time : 2 Seconds
bridge Maximum Age : 20 Seconds
bridge Forward Delay : 15 Seconds
time-since-top-change: 89185 Seconds
topology-change-count: 0
Enterprise AP#
- EliteConnect 2
- SMC2552W-G2 2
- 2.4GHz Wireless Access Point 2
- Copyright 3
- Japan VCCI Class B 5
- EC Conformance Declaration 5
- Safety Compliance 8
- OMPLIANCES 10
- COMPLIANCES 11
- Table of Contents 14
- Contents 21
- Chapter 1: Introduction 22
- Indicators 23
- Antennas 23
- Component Description 24
- Introduction 25
- Security Slot 25
- Console Port 25
- Ethernet Port 25
- Features and Benefits 26
- System Defaults 27
- Hardware Installation 33
- Chapter 3: External Antennas 34
- External Antennas 35
- Installation Procedures 36
- Network Topologies 39
- Infrastructure Wireless LAN 40
- Network Configuration 41
- Required Connections 44
- Initial Configuration Steps 45
- Logging In 46
- Initial Configuration 47
- Advanced Configuration 49
- System Identification 50
- TCP / IP Settings 52
- SSH Settings 58
- Authentication 59
- Filter Control 64
- WDS Settings 68
- AP Management 74
- Administration 75
- Upgrading Firmware 76
- System Log 79
- Configuring SNTP 81
- Configuring SNMPv3 Users 89
- Configuring SNMPv3 Targets 93
- Radio Interface 100
- System Configuration 101
- Configuring Wi-Fi Multimedia 104
- Security 109
- Enabling the VAPs 113
- Wi-Fi Protected Access (WPA) 120
- Configuring 802.1X 126
- Status Information 129
- Station Status 132
- Event Logs 135
- Chapter 7: 138
- Command Line Interface 138
- Entering Commands 139
- Command Completion 140
- Getting Help on Commands 140
- Showing Commands 140
- Enterprise AP#show s? 141
- Enterprise AP#show s 141
- Exec Commands 142
- Configuration Commands 142
- Command Groups 143
- General Commands 144
- System Management Commands 148
- APmgmtIP 158
- APmgmtUI 159
- System Logging Commands 165
- System Clock Commands 170
- DHCP Relay Commands 175
- SNMP Commands 177
- Flash/File Commands 192
- RADIUS Client 196
- 802.1X Authentication 202
- 802.1x session-timeout 204
- 802.1x-supplicant enable 205
- 802.1x-supplicant user 205
- MAC Address Authentication 207
- Filtering Commands 210
- WDS Bridge Commands 214
- Spanning Tree Commands 220
- Ethernet Interface Commands 225
- Wireless Interface Commands 230
- Rogue AP Detection Commands 246
- Wireless Security Commands 251
- Link Integrity Commands 260
- IAPP Commands 264
- VLAN Commands 265
- WMM Commands 267
- Appendix A: Troubleshooting 272
- Troubleshooting 273
- 10/100BASE-TX Pin Assignments 274
- Straight-Through Wiring 275
- Crossover Wiring 276
- Wiring Map for Serial Cable 277
- Appendix C: Specifications 278
- °C (32 to 122 °F) 279
- °C (32 to 158 °F) 279
- General Specifications 280
- Sensitivity 281
- Transmit Power 281
- Operating Range 283
- Glossary 284
- Virtual Access Point (VAP) 288
- Virtual LAN (VLAN) 288
- Wi-Fi Protected Access 288
- WPA Pre-shared Key (PSK) 288
- Model Number: SMC2552W-G2-17 295
- Pub. Number: 150000030500E 295
- E052006-DT-R01 295
- 38 Tesla 296
- Irvine, CA 92618 296
- Phone: (949) 679-8000 296
Relacionado con productos y manuales para Hardware Smc-networks SMC2552W-G2-17
Hardware Smc-networks SMC2482W Manual de usuario
(50 paginas)
(50 paginas)
Hardware Smc-networks EX120-SDN1 Manual de usuario
(13 paginas)
(13 paginas)
Hardware Smc-networks SMC7204BRA Manual de usuario
(56 paginas)
(56 paginas)
Hardware Smc-networks SMC2835W Manual de usuario
(33 paginas)
(33 paginas)
Hardware Smc-networks SMCWTVG Manual de usuario
(5 paginas)
(5 paginas)
Hardware Smc-networks SMCWAA-B Manual de usuario
(51 paginas)
(51 paginas)
Hardware Smc-networks 486DX4 Manual de usuario
(81 paginas)
(81 paginas)
Hardware Smc-networks EZ Connect 2-Port ADSL Bridge Router SMC7003ADSL Manual de usuario
(2 paginas)
(2 paginas)
Hardware Smc-networks SMC9452TX-2 Manual de usuario
(41 paginas)
(41 paginas)
(124 paginas)
Hardware Smc-networks SMCHP1D-ETH Manual de usuario
(26 paginas)
(26 paginas)
Hardware Smc-networks SMC7008ABR Manual de usuario
(46 paginas)
(46 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.064 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales