SMC Networks ADSL2 Manual de usuario descargar pdf (Pagina 28)

3.5.1 Basic Settings

Choose WLAN > Basic Settings. The page shown in the following figure appears. In this page, you can configure

the parameters for wireless LAN clients that may connect to your access point.

The following table describes the parameters and buttons of this page.

Field Description

Disable Wireless LAN

Interface

By default, the wireless LAN is enabled. Select it to disable the wireless LAN.

(Root) SSID

The service set identification (SSID) is a unique name to identify the router in the

wireless LAN. Wireless stations associating to the router must have the same

SSID. Enter a desciptive name.

Set VSSID

Click it, the Virtual SSID Setting page appears. In this page, you can enable 4

VSSIDs at most.

SSID You can enable or disnable SSID.

Country/Area Select the region which you are in.

Channel Number

A channel is the radio frequency used by 802.11b/g wireless device. Channels

available depend on your geographical area. You may have a choice of channels

(for your region) and you should use a different channel from an adjacent AP to

reduce the interference. Interference and degrading performance occurs when

radio signal from diffirent APs overlap.

Select a channel from the drop-down list box.

Apply Changes Save the settings of this page.

Click Set VSSID, the page shown in the following figure appears.

25

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 71 72

Sin comentarios

SMC Networks ADSL2 Manual de usuario Pagina 28