SMC Networks SMC6608M Manual de usuario descargar pdf (Pagina 64)

6. Highlight “Default Gateway” and press <ENTER> to set the

default gateway IP address to which the unit will send IP

packets destined for a different subnet. Press <ENTER>

again to confirm entry.

7. Highlight “Subnet Mask” and press <ENTER> to set the sub-

net mask corresponding to the assigned IP address. Press

<ENTER> again to confirm entry.

8. Highlight “IP State” and press <ENTER> to specify whether

the switch’s IP address is set by the Boot Protocol (BOOTP).

The options are:

♦ IP Disabled: Prevents the switch from processing any IP

information it receives.

♦ BOOTP When Needed: This is the default option. Will

only try to set the IP address if the address stored in the

EEPROM is 0.0.0.0

♦ BOOTP Always: Will clear any non-zero IP address from

the EEPROM to zero when the switch is booted.

9. Highlight “Send Ping” and press <ENTER> to issue an ICMP

echo request to a specified IP address. Press <ENTER> again

to send the echo request to the IP address specified. Used

to verify validity of address (i.e., that a device can be

reached).

4-13

CONFIGURATION AND MANAGEMENT

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 112 113

Sin comentarios

SMC Networks SMC6608M Manual de usuario Pagina 64