Smc-networks SMC2555W-AG Manual de usuario descargar pdf (Pagina 116)

System Configuration

5-60

authentication. To view the current 802.11g security settings, use

the show interface wireless a or show interface wireless g

command (not shown in example).

CLI Commands for WPA over 802.1x Security – From the

802.11a or 802.11g interface configuration mode, use the

authentication command to set the access point to “Open

System.” Use the WEP encryption command to enable all types

of encryption. Use the wpa-clients command to set WPA to be

required or supported for clients. Use the wpa-mode command

to enable WPA dynamic keys over 802.1x. Set the broadcast and

multicast key encryption using the multicast-cipher command.

Then set 802.1x to required, and disable MAC authentication. To

view the current 802.11g security settings, use the show

interface wireless g command (not shown in example).

SMC-AP(config)#interface wireless g 6-68

Enter Wireless configuration commands, one per line.

SMC-AP(if-wireless g)#authentication open 6-83

SMC-AP(if-wireless g)#encryption 128 6-84

SMC-AP(if-wireless g)#wpa-clients required 6-90

SMC-AP(if-wireless g)#wpa-mode pre-shared-key 6-92

SMC-AP(if-wireless g)#wpa-psk-type alphanumeric 6-94

SMC-AP(if-wireless g)#wpa-preshared-key ASCII asecret 6-93

SMC-AP(if-wireless g)#end

SMC-AP(config)#no 802.1x 6-51

SMC-AP(config)#no mac-authentication 6-57

SMC-AP(config)#interface wireless g 6-68

Enter Wireless configuration commands, one per line.

SMC-AP(if-wireless g)#authentication open 6-83

SMC-AP(if-wireless g)#encryption 128 6-84

SMC-AP(if-wireless g)#wpa-clients required 6-90

SMC-AP(if-wireless g)#wpa-mode dynamic 6-92

SMC-AP(if-wireless g)#multicast-cipher TKIP 6-89

SMC-AP(if-wireless g)#end

SMC-AP(config)#802.required 6-51

SMC-AP(config)#no mac-authentication 6-57

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 255 256

Sin comentarios

Smc-networks SMC2555W-AG Manual de usuario Pagina 116