SMC Networks L2-Lite Manual de usuario descargar pdf (Pagina 255)

100

101

Quality of Service

3-207

CLI – This example creates a policy map called “rd-policy,” sets the average

bandwidth the 1 Mbps, the burst rate to 1522 bps, and the response to reduce the

DSCP value for violating packets to 0.

Attaching a Policy Map to Ingress Queues

This function binds a policy map to the ingress queue of a particular interface.

Command Usage

• You must first define a class map, then define a policy map, and finally bind the

service policy to the required interface.

• You can only bind one policy map to an interface.

• The current firmware does not allow you to bind a policy map to an egress queue.

Command Attributes

• Ports – Specifies a port.

• Ingress – Applies the rule to ingress traffic.

• Enabled – Check this to enable a policy map on the specified port.

• Policy Map – Select the appropriate policy map from the scroll-down box.

Web – Click QoS, DiffServ, Service Policy Settings. Check Enabled and choose a

Policy Map for a port from the scroll-down box, then click Apply.

Figure 3-120 Service Policy Settings

Console(config)#policy-map rd_policy#3 4-261

Console(config-pmap)#class rd_class#3 4-261

Console(config-pmap-c)#set ip dscp 4 4-262

Console(config-pmap-c)#police 100000 1522 exceed-action

set ip dscp 0 4-263

Console(config-pmap-c)#

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 613 614

Comentarios a estos manuales

Sin comentarios

SMC Networks L2-Lite Manual de usuario Pagina 255

Comentarios a estos manuales

Relacionado con productos y manuales para Software SMC Networks L2-Lite