SMC Networks SMC8724ML3 Manual de usuario descargar pdf (Pagina 23)

ESCRIPTION

ARDWARE

1-3

These switches include built-in stacking ports that enable up to eight units

to be connected together through a 40 Gbps stack backplane. The switch

stack can be managed from a master unit using a single IP address.

These switches also include a slot on the rear panel for slide-in single-port

10G modules with Xenpak transceivers.

Network Management Options

These switches contain a comprehensive array of LEDs for “at-a-glance”

monitoring of network and port status. They also include a management

agent that allows you to configure or monitor the switch using its

embedded management software, or via SNMP applications. To manage

the switch, you can make a direct connection to the RS-232 console port

(out-of-band), or you can manage the switch through a network

connection (in-band) using Telnet, the on-board web agent, or

SNMP-based network management software.

For a detailed description of both switches’ advanced features, refer to the

Management Guide.

Description of Hardware

10/100/1000BASE-T Ports

The switches contain 24/48 RJ-45 ports that operate at 10 Mbps or

100 Mbps, half or full duplex, or at 1000 Mbps, full duplex. Because all

ports on these switches support automatic MDI/MDI-X operation, you

can use straight-through cables for all network connections to PCs or

servers, or to other switches or hubs. (See “1000BASE-T Pin

Assignments” on page B-5.)

Each of these ports support auto-negotiation, so the optimum

transmission mode (half or full duplex), and data rate (10, 100, or

1000 Mbps) can be selected automatically. If a device connected to one of

these ports does not support auto-negotiation, the communication mode

of that port can be configured manually.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 91 92

Sin comentarios

SMC Networks SMC8724ML3 Manual de usuario Pagina 23