Smc-networks SMCBGSLCX1 Manual de usuario

TigerSwitch 10/10050-Port Layer 2 Switch◆ 48 10BASE-T/100BASE-TX auto-MDI/MDI-X ports◆ 2 auto-MDI/MDI-X 10/100/1000BASE-T combo ports with associated

COMPLIANCESviSafety ComplianceWarning: Fiber Optic Port SafetyAvertissment: Ports pour fibres optiques - sécurité sur le plan optiqueWarnhinweis: Fase

COMPLIANCESviiWichtige Sicherheitshinweise (Germany)1. Bitte lesen Sie diese Hinweise sorgfältig durch.2. Heben Sie diese Anleitung für den späteren

COMPLIANCESviii

ixCONTENTS1 About the TigerSwitch 10/100 . . . . . . . . . . . . . . 1-1Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CONTENTSxSMC 5-4-3 Rule . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-8Application Notes . . . . . . . . . . . . . . . . .

CONTENTSxiConsole Port to 25-Pin DTE Port on PC . . . . . . . . . . . . . . . . . . B-7C Specifications . . . . . . . . . . . . . . . . . . . . . .

CONTENTSxii

1-1CHAPTER 1ABOUT THETIGERSWITCH 10/100OverviewSMC’s TigerSwitch™ 10/100 is an intelligent Fast Ethernet switch with 48 10BASE-T/100BASE-TX ports and

ABOUT THE TIGERSWITCH 10/1001-2Switch ArchitectureThe TigerSwitch 10/100 employs a wire-speed, non-blocking switching fabric. This permits simultaneou

OVERVIEW1-3Spanning Tree ProtocolThe TigerSwitch 10/100 supports IEEE 802.1D Spanning Tree Protocol. This protocol adds a level of fault tolerance by

ABOUT THE TIGERSWITCH 10/1001-4Multicast SwitchingSpecific multicast traffic can be assigned to its own VLAN to ensure that it does not interfere with

DESCRIPTION OF HARDWARE1-5Description of Hardware10BASE-T/100BASE-TX PortsThese are dual-speed RJ-45 ports. Because all ports on this switch support a

ABOUT THE TIGERSWITCH 10/1001-6Status LEDs The LEDs, which are located on the front panel for easy viewing, are shown below and described in the follo

DESCRIPTION OF HARDWARE1-7System Status LEDsLED Condition StatusPower On Green The unit’s internal power supply is operating normally.On Red The unit’

ABOUT THE TIGERSWITCH 10/1001-8Optional Redundant Power UnitSMC provides an optional Redundant Power Unit (RPU), SMCRPS600W, that can supply power to

FEATURES AND BENEFITS1-9Features and BenefitsConnectivity◆ 48 dual-speed ports for easy Fast Ethernet integration and for protection of your investmen

ABOUT THE TIGERSWITCH 10/1001-10Performance◆ Transparent bridging◆ Provides Store-and-Forward switching ◆ Supports flow control, using back pressure f

FEATURES AND BENEFITS1-11Management◆ “At-a-glance” LEDs for easy troubleshooting◆ Network management agent:• Web-based management with embedded HTTP s

ABOUT THE TIGERSWITCH 10/1001-12

2-1CHAPTER 2NETWORK PLANNINGIntroduction to SwitchingA network switch allows simultaneous transmission of multiple packets via non-crossbar switching.

38 TeslaIrvine, CA 92618Phone: (949) 679-8000TigerSwitch 10/100Installation GuideFrom SMC’s Tiger line of feature-rich workgroup LAN solutionsJune 200

NETWORK PLANNING2-2Sample ApplicationsThe TigerSwitch 10/100 is not only designed to segment your network, but also to provide a wide range of options

SAMPLE APPLICATIONS2-3Central Wiring ClosetWith 50 parallel bridging ports (i.e., 50 distinct collision domains), the TigerSwitch 10/100 can collapse

NETWORK PLANNING2-4Remote Connections with Fiber CableFiber optic technology allows for longer cabling than any other media type. A 1000BASE-LX SFP tr

SAMPLE APPLICATIONS2-5Making VLAN ConnectionsVLANs can be based on port groups, or each data frame can be explicitly tagged to identify the VLAN group

NETWORK PLANNING2-6Connectivity RulesWhen adding hubs (repeaters) to your network, please follow the connectivity rules listed below for Ethernet, Fas

CONNECTIVITY RULES2-7100 Mbps Fast Ethernet Collision DomainMaximum Fast Ethernet Cable DistanceSMC 3-2 Rule for Class II RepeatersSMC 2-1 Rule for Cl

NETWORK PLANNING2-810 Mbps Ethernet Collision DomainMaximum Ethernet Cable Distance Maximum Network Diameter Using Repeaters SMC 5-4-3 Rule Cable Type

APPLICATION NOTES2-9Application Notes1. Full-duplex operation only applies to point-to-point access (such as when a switch is attached to a workstatio

NETWORK PLANNING2-10

3-1CHAPTER 3INSTALLING THE SWITCHSelecting a SiteTigerSwitch 10/100 units can be mounted in a standard 19-inch equipment rack or on a flat surface. Be

Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, n

INSTALLING THE SWITCH3-2Equipment ChecklistAfter unpacking the TigerSwitch 10/100, check the contents to be sure you have received all the components.

MOUNTING3-3MountingA TigerSwitch 10/100 unit can be mounted in a standard 19-inch equipment rack or on a desktop or shelf. Mounting instructions for e

INSTALLING THE SWITCH3-4To rack-mount devices:1. Attach the brackets to the device using the screws provided in the Bracket Mounting Kit.Figure 3-1.

MOUNTING3-53. If installing a single switch only, turn to “Connecting to a Power Source” at the end of this chapter.4. If installing multiple switches

INSTALLING THE SWITCH3-6Connecting to a Power SourceTo connect a device to a power source:1. Insert the power cable plug directly into the receptacle

4-1CHAPTER 4MAKING NETWORKCONNECTIONSConnecting Network DevicesThe TigerSwitch 10/100 is designed to interconnect multiple segments (or collision doma

MAKING NETWORK CONNECTIONS4-2Note: If auto-negotiation is disabled for an RJ-45 port, the auto-MDI/MDI-X pin signal configuration is also disabled.See

TWISTED-PAIR DEVICES4-33. As each connection is made, the green Link LED (on the TigerSwitch) corresponding to each port will light to indicate that t

MAKING NETWORK CONNECTIONS4-4

A-1APPENDIX ATROUBLESHOOTINGDiagnosing Switch Indicators Power and Cooling ProblemsIf the power indicator does not turn on when the power cord is plug

iLIMITED WARRANTYLimited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship and materials, un

TROUBLESHOOTINGA-2outlet, and verify that the fans on the unit are unobstructed and running prior to shutdown. If you still cannot isolate the problem

B-1APPENDIX BCABLESSpecifications Cable Types and SpecificationsCable Type Max. Length Connector10BASE-T Cat. 3, 4, 5 100-ohm UTP 100 m (328 ft) RJ-45

CABLESB-2Twisted-Pair Cable and Pin AssignmentsCaution: DO NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair cables with RJ-4

TWISTED-PAIR CABLE AND PIN ASSIGNMENTSB-3100BASE-TX/10BASE-T Pin AssignmentsWith 100BASE-TX/10BASE-T cable, pins 1 and 2 are used for transmitting dat

CABLESB-41000BASE-T Pin Assignments1000BASE-T ports switch support automatic MDI/MDI-X operation, so you can use straight-through cables for all netwo

TWISTED-PAIR CABLE AND PIN ASSIGNMENTSB-51000BASE-T Cable RequirementsAll Category 5 UTP cables that are used for 100BASE-TX connections should also w

CABLESB-6Console Port Pin AssignmentsThe DB-9 serial port on the switch’s rear panel is used to connect to the switch for out-of-band console configur

CONSOLE PORT PIN ASSIGNMENTSB-7Console Port to 25-Pin DTE Port on PCSwitch’s 9-Pin Serial PortNull Modem PC’s 25-Pin DTE Port2 RXD <---------RXD -

CABLESB-8

C-1APPENDIX CSPECIFICATIONSPhysical CharacteristicsPorts48 10BASE-T/100BASE-TX, with auto-negotiationTwo 10/100/1000BASE-T shared with two SFP transce

LIMITED WARRANTYiiLIABILITY IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE OR USE OF ITS PRODUCTS. SMC SHALL NOT BE LIABLE UNDER THIS WARRANTY

SPECIFICATIONSC-2TemperatureOperating: 0 to 50 °C (32 to 122 °F)Storage: -40 to 70 °C (-40 to 158 °F)HumidityOperating: 10% to 90%AC Input100 to 240 V

SWITCH FEATURESC-3Switch FeaturesSpanning Tree ProtocolForwarding ModeStore-and-forwardFlow ControlFull Duplex: IEEE 802.3xHalf Duplex: Back pressureB

SPECIFICATIONSC-4Management FeaturesIn-Band ManagementTelnet, Web-based HTTP, or SNMP manager(EliteView Network Management software provided free)Out-

COMPLIANCESC-5CompliancesCE MarkEmissionsFCC Class AIndustry Canada Class AEN55022 (CISPR 22) Class AEN 61000-3-2/3VCCI Class AC-Tick - AS/NZS 3548 (1

SPECIFICATIONSC-6

D-1APPENDIX DORDERING INFORMATIONTigerSwitch 10/100 Products and AccessoriesProduct Number DescriptionSMC6750L2 48 10/100 Mbps ports switch with two G

ORDERING INFORMATIOND-2

Glossary-1GLOSSARY10BASE-TIEEE 802.3 specification for 10 Mbps Ethernet over two pairs of Category 3, 4, or 5 UTP cable.100BASE-TXIEEE 802.3u specific

GLOSSARYGlossary-2BandwidthThe difference between the highest and lowest frequencies available for network signals. Also synonymous with wire speed, t

GLOSSARYGlossary-3Gigabit EthernetA 1000 Mbps network communication system based on Ethernet and the CSMA/CD access method. Full DuplexTransmission me

iiiCOMPLIANCESFCC - Class AThis equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with th

GLOSSARYGlossary-4LAN SegmentSeparate LAN or collision domain.LEDLight emitting diode used for monitoring a device or network condition.Local Area Net

GLOSSARYGlossary-5Transmission Control Protocol/Internet Protocol (TCP/IP)Protocol suite that includes TCP as the primary transport protocol, and IP a

GLOSSARYGlossary-6

Index-1Numerics10 Mbps connectivity rules 2-81000 Mbps connectivity rules 2-61000BASE-LXfiber cable lengths 2-61000BASE-SXfiber cable lengths 2-6100BA

INDEXIndex-2IIEEE 802.3x flow control 1-5IGMP 1-2indicators, LED 1-6installationconnecting devices to the switch 4-2desktop or shelf mounting 3-5port

INDEXIndex-3RJ-45 port connections 4-1RJ-45 ports 1-5pinouts B-4RMON 1-2routing applications 2-9RPUconnecting 3-6installing in a rack 3-5installing on

INDEXIndex-4

38 TeslaIrvine, CA 92618Phone: (949) 679-8000Model Number: SMC6750L2Publication Number: 150200016500ARevision Number: E062002-R01FOR TECHNICAL SUPPORT

COMPLIANCESivvoltage limits and the Amendment Directive 93/68/EEC. For the evaluation of the compliance with these Directives, the following standards

COMPLIANCESvIndustry Canada - Class AThis digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set