Smc-networks ProSoft 1560 Manual de usuario descargar pdf (Pagina 38)

Contents

Addressing

Pay careful attention to the dip switch address configuration. EACH

1560-MBP on the network must have it own unique address. This

MUST also be different from the PLC address. ALL drives should in

general have their Host address set to the PLC ís address.

Hints

Note that the Stop bit is set to 1 to stop drive. If communication is lost,

the PLC is unable to remotely stop the drive. In general, when

controlling drive functions, SW2-8 should be set ON so that the drive will

fault on loss of Modbus Plus communications. In addition, when drives

are controlling hazardous operations, a hard wired interlock to the drive

should be provided.Other devices may be used on the same Modbus

Plus network, but the user must pay close attention to any use of Global

Data to insure compatibility.

Appendix C — Peer Cop Example

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Sin comentarios

Smc-networks ProSoft 1560 Manual de usuario Pagina 38