Smc-networks EliteConnect SMCWHSG14-G Manual de usuario descargar pdf (Pagina 176)

SMCWHSG14-G

175

Appendix A Signal Connection Arrangements

RJ-45 Ethernet Port

The Wireless Hotspot Gateway RJ-45 Ethernet port can connect to any networking devices that use a

standard LAN interface, such as a Hub/Switch Hub or Router. Use unshielded twisted-pair (UTP) or

shield twisted-pair (STP) cable to connect the networking device to the RJ-45 Ethernet port.

Depending on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as

prescribed.

10Mbps: Use EIA/TIA-568-100-Category 3, 4 or 5 cable.

100Mbps: Use EIA/TIA-568-100-Category 5 cable.

Figure A-1 RJ-45 Connector and Cable Pins

Note: To prevent loss of signal, make sure that the length of any twisted-pair connection does not

exceed 100 meters.

1 2 ... 171 172 173 174 175 176 177 178

Sin comentarios

Smc-networks EliteConnect SMCWHSG14-G Manual de usuario Pagina 176