Smc-networks SMC TigerStack IV SMC6224M Manual de usuario Pagina 236

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 522
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 235
C
ONFIGURING
THE
S
WITCH
3-182
CLI – The following example globally enables IP Port Priority service on
the switch, maps HTTP traffic on port 5 to CoS value 0, and then displays
all the IP Port Priority settings for that port.
Note: Mapping specific values for IP Port Priority is implemented as an
interface configuration command, but any changes will apply to
the all interfaces on the switch.
Mapping CoS Values to ACLs
Use the ACL CoS Mapping page to set the output queue for packets
matching an ACL rule as shown in the following table. Note that the
specified CoS value is only used to map the matching packet to an output
queue; it is not written to the packet itself. For information on mapping
the CoS values to output queues, see page 3-171.
Command Attributes
Port – Port identifier.
Name
14
– Name of ACL.
Type – Type of ACL (IP or MAC).
CoS Priority – CoS value used for packets matching an IP ACL rule.
(Range: 0-7)
Console(config)#map ip port 4-228
Console(config)#interface ethernet 1/5
Console(config-if)#map ip port 80 cos 0 4-228
Console(config-if)#end
Console#show map ip port ethernet 1/5 4-228
TCP port mapping status: enabled
Port Port no. COS
--------- -------- ---
Eth 1/ 5 80 0
Console#
Table 3-14 Egress Queue Priority Mapping
Queue
0123
Priority
1,2 0,3 4,5 6,7
14. For information on configuring ACLs, see page 3-77.
Vista de pagina 235
1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 521 522

Comentarios a estos manuales

Sin comentarios