Smc-networks SMC EliteConnect SMC2586W-G Manual de usuario descargar pdf (Pagina 42)

Fig. 42 Wireless Distribution System settings.

To enable a WDS link:

3. Specify the MAC address of the AP or bridge at the other end of the WDS

link.

4. Select the corresponding Enabled check box.

For example, assume you want two SMC2586W-Gs with MAC addresses 00-

02-65-01-62-C5 and 00-02-65-01-62-C6 to establish a WDS link between

them. On SMC2586W-G 00-02-65-01-62-C5, set the peer MAC address of

port 1 to 00-02-65-01-62-C6 and on SMC2586W-G 00-02-65-01-62-C6, set

the peer MAC address of port 1 to 00-02-65-01-C5.

TIP: Plan your wireless network and draw a diagram, so that you know how

an AP is connected to other peer APs or wireless bridges by WDS.

TIP: Plan your wireless network and draw a diagram, so that you know how a

bridge is connected to other peer bridges by WDS. See the following figure

for an example network-planning diagram.

Fig. 43 Sample wireless bridge network topology.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 95 96

Sin comentarios

Smc-networks SMC EliteConnect SMC2586W-G Manual de usuario Pagina 42